Pressure washer adapter connecting a wand to its hose on a patio

M22 describes the thread size, but the fitting also has a 14mm or 15mm inside diameter, and an adapter built for one can leak on the other. Check which one your pressure washer, gun or hose uses before you order.

Why this matters

Our M22-14 swivel and 3/8 inch adapter set carries a clear note: the swivel is a 14mm fitting with an inside diameter of 14mm, not 15mm. If your fitting is 15mm, it may leak, and it may not suit some electric pressure washers that have an M22 15mm fitting. Thread size is the same, so the two look alike on the shelf.

How to find out which you have

  1. Read the manual or spec sheet. Look for "M22-14" or "M22-15" in the connector listing for the pump outlet and gun.
  2. Look at the markings. Some fittings are stamped with the size on the nut or body.
  3. Measure the inside diameter of the male end with calipers if you have them. About 14mm is a 14 fitting, about 15mm is a 15.
  4. Ask the maker. If the washer is unmarked, the manufacturer's support can confirm the size from the model number.

Do not guess. A fitting that is a little loose can leak at the pump, which makes it hard to build pressure. Our post on pressure loss covers other causes.

What is in the adapter set

Pieces (per the listing) Use
2 x M22 14mm quick-connect swivel + 3/8 quick connect Pump outlet to hose, or hose to gun
2 x 3/8 inch QD + M22-14 male Quick-disconnect on 14mm M22 ends
2 x 3/4 inch female + 1/2 inch quick connect Garden hose to the washer inlet
2 x 1/2 inch plug + 3/4 inch male Inlet side adapters

The listing states a working pressure up to 5,000 PSI and corrosion-resistant brass. Your washer, hose and gun must also be rated for your pressure.

If you have a 15mm washer

Look for an adapter that is listed as 15mm. Do not wrap tape or add extra washers to make a 14mm part fit, which can cause leaks under pressure.

For help choosing between quick-connect sizes, read M22 vs 3/8 quick connect. For general fitting basics see pressure washer fittings explained.

Fittings, M22, Pressure washer