Pressure washer adapter connecting a wand to its hose on a patio

M22 vs. 3/8 Inch Quick Connect: Which Pressure Washer Fitting Do You Have?

Most consumer pressure washers use one of two fitting styles at the pump outlet: an M22 threaded connection (common on gas pressure washers and many electric ones) or a 3/8" quick-connect plug-and-socket (common on hoses, guns, and wands). If your hose end doesn't match your pump, you need an adapter — not a different hose.

How to tell which one you have

  • M22: a round metal fitting with fine screw threads on the inside or outside, usually at the pump outlet or the base of the trigger gun. It threads on and needs a few full turns to seat.
  • 3/8" quick-connect: a spring-loaded plug and socket pair that snaps together with a push and a click, no threading. Common at the hose-to-wand or hose-to-gun joint.

Most pressure washers actually use both: M22 threads where the hose meets the pump, and a 3/8" quick-connect further down where the hose meets the gun or wand. That's why a single adapter set that covers both ends is more useful than buying one fitting at a time.

The one M22 detail that causes most return requests

M22 fittings come in two inside diameters that look nearly identical: 14mm and 15mm. The Pressure Washer Adapter Set uses the 14mm swivel fitting, which fits the majority of gas pressure washers and many electric models. If your pump uses a 15mm M22 fitting instead, this adapter will not seal properly and will leak at the threads — that's a compatibility mismatch, not a defective part. Measure the inside diameter of your existing fitting with a small ruler or caliper before ordering if you're not sure which size your pump uses.

What's in this adapter set and what each piece solves

  • M22-14 swivel to 3/8" quick connect — lets a hose with a 3/8" plug end connect to a pump or gun that only has M22-14 threads, and the swivel keeps the hose from kinking as you move around.
  • 3/8" quick connect to M22-14 male — the reverse direction, for when your hose has the M22 thread and your gun or wand expects a quick-connect plug.
  • 3/4" female to 1/2" quick connect, and 1/2" plug to 3/4" male — these convert a standard 3/4" garden hose thread into the washer's water-inlet quick-connect, so you can feed tap water into the pump without extra parts.

Rated to 5,000 PSI and made of corrosion-resistant brass, these are sized for the pump-and-gun side of the system — not for cleaning attachments like nozzles or surface cleaners, which thread onto the wand separately.

Still not sure it'll fit?

Check your pressure washer's manual for the fitting type at the pump outlet before buying — manufacturers list it as "M22" or "quick connect" in the specs. If your pump already came with its own quick-connect socket pre-installed and you just need to replace a worn O-ring instead of the whole fitting, that's a different, cheaper fix — see our guide on pressure washer hose leaking at the connector.

Buying guide, How to, Pressure washer