A typical 3 ft wide, 6 ft tall bookshelf with five shelves needs about 27 ft of wire for one pass along every shelf edge and both sides, so one 33 ft strand is tight and a 99 ft strand leaves plenty to spare.
The measuring method
Add up the edges you want to light. Example (an assumption, not a standard size): 5 shelf edges x 3 ft = 15 ft, plus two sides x 6 ft = 12 ft, for 27 ft. If you zigzag the wire on each shelf to fill the space, double the shelf run: 5 x 3 x 2 = 30 ft, plus 12 ft for the sides = 42 ft.
| Layout | Wire for the example shelf | Fits 33 ft? | Fits 99 ft? |
|---|---|---|---|
| One pass along every shelf edge + sides | 27 ft | Yes (6 ft spare) | Yes |
| Zigzag on each shelf + sides | 42 ft | No | Yes |
| Zigzag + weave around objects | about 60 ft | No | Yes |
Which strand to use
The 300 LED 99 ft copper wire lights are battery powered (6 AA, not included) with a remote for brightness, 8 modes and a 6-on, 18-off timer. 300 LEDs over 99 ft is an average of about 4 inches apart (our own division, since the listing does not state the spacing). For a short shelf the 33 ft warm white copper wire lights work if you do one pass.
How to attach it
- Start at the bottom and work up, so any leftover wire finishes near the battery box.
- Use small adhesive clips along the underside of each shelf edge so the bulbs face down onto books and objects.
- Hide the battery box behind the unit, in a basket, or on the top shelf with a gap for the remote's line of sight.
- Do not run wire through spots where doors or drawers pinch it.
Make it look intentional
- Tuck wire behind a front lip rather than leaving it on top of the books.
- Skip a shelf or two instead of lighting every shelf evenly, so the display has focus.
- Keep the lights from touching paper for hours. LED wire runs cool, but still leave a bit of space.
See also how to store copper wire lights without tangling when you take them down, and bedroom ideas for other indoor uses.
