Solar string lights with 8 modes and a memory function remember the last mode you chose after the power is switched off, so you only need to set the mode once. The mode does not reset at sunset. Here is how the modes behave, how to change them, and how to get a full night of light.
What the 8 modes look like
The Twinkle Star 120 LED solar string lights list these 8 modes:
| Mode | What to expect | Best for |
|---|---|---|
| Combination | Cycles through several effects | Parties, a lively look |
| In Waves | Light moves in waves along the strand | Fence lines and rooflines |
| Sequential | Sections light one after another | Trees and long runs |
| Slow Glow | Gentle brightening and dimming | Relaxed patios |
| Chasing/Flash | Fast moving flashes | Festive displays |
| Slow Fade | Slow fade in and out | Quiet evenings |
| Twinkle/Flash | Random twinkling | Trees and shrubs |
| Steady On | Constant light | Maximum usable light |
How the memory function helps
According to the product listing, the lights remember the last setting automatically after the power is turned off, with no need to reset. In practice that means you can leave the switch on, pick a mode once, and not touch it again. If you switch the strand off at the panel and back on later, it should return to the mode you left it in.
Changing the mode
- Check that the panel's switch is on. The labeled diagram on the product page shows the on/off switch and the mode control on the solar panel stake.
- Press the mode control once per step until you reach the effect you want.
- Wait a few seconds on each mode; some effects pause between phases and look inactive.
Which mode saves the most light for long nights?
The listing does not publish a separate runtime for each mode, so we can't promise a specific hour count by mode. It says that after 8 to 12 hours of full, direct sunlight, the lights run for roughly 10 to 14 hours, depending on the weather. If your lights fade early in winter, choose Steady On for the most reliable output and make sure the panel is fully in the sun. Our guide to placing solar string lights and panels explains where to put the stake, and solar lights in winter covers short days.
If the mode does not seem to change
- Confirm it is dark enough. Solar lights typically switch on only when the panel senses low light.
- Cover the panel with your hand to simulate night during testing.
- Clean dust or leaves off the panel; shading cuts charging.
- Charge fully for a day before judging performance.
Choosing a mode by location
Sequential and In Waves look best along a fence or a long run. Twinkle works on trees and shrubs. Steady On is the practical choice for a seating area where you need actual light, not just effect. The strand is 39.4 ft with a 6.5 ft cord, so measure the distance from the panel to where you want the lights before you hang them.
