Coiled purple LED copper wire fairy lights with remote control and waterproof battery box

If your fairy light remote stops working, the problem is almost always one of four things: a weak battery in the controller or the remote, the remote pointed away from the receiver, the lights stuck in the wrong mode or timer state, or a loose battery-box connection. Work through the checks below in order. Most take under a minute.

Step 1: Check the batteries in both places

Battery-powered strands have two power sources: the AA batteries in the light's battery box and the small battery inside the remote. Our 100 LED purple fairy lights and blue fairy lights use 3 AA batteries per strand (not included). The remote has its own battery, so a strand that glows but ignores the remote often just needs a fresh remote cell.

  • Replace all three AA batteries together; never mix old and new.
  • Open the remote's battery compartment and check the battery type printed there before buying a replacement.
  • Make sure the battery tab, if there is one, has been pulled out.

Step 2: Aim and distance

Point the remote at the battery box (the receiver sits in or near the controller), not at the wire or the bulbs. If the box is tucked behind a planter, inside a wreath, or under snow, the signal can be blocked. Try the remote from 3 to 6 feet away with a clear line first, then move back to see where it starts to fail.

Step 3: Understand what the buttons actually do

On the 13-key remotes that ship with our purple and blue strands, the buttons cover power on/off, timer, brightness up and down, and the 8 lighting modes (Combination, In Waves, Sequential, Slow Glow, Chasing/Flash, Slow Fade, Twinkle/Flash and Steady On). Two behaviors are often mistaken for a fault:

  • Timer: the 6-hour-on, 18-hour-off timer means the lights turn themselves off after 6 hours and stay off until the next cycle. If you pressed the timer key by accident, the strand can look "dead" in the daytime or the next evening.
  • Brightness: if brightness was stepped all the way down, a lit strand can look off in a bright room. Press brightness up a few times.
  • Mode: in a slow fade or twinkle mode, the lights may pause between phases. Switch to Steady On to confirm they work.

Step 4: Check the battery box

Press the power button on the battery box itself. If the lights respond there but not on the remote, the strand is fine and the remote is the issue. If they do not respond at all, reseat the batteries, close the lid firmly, and check that the plug between the wire and the box is pushed in fully. The wire on these strands is sealed, but the battery box is only rated IP44, so keep it out of standing water and off the ground where it can collect moisture.

Step 5: Reset and test indoors

Bring the strand inside, install fresh batteries, and test with the remote at arm's length. If it works indoors, the outdoor setup (cold, moisture, blocked line of sight) was the cause. In cold weather, battery output drops. Our guide to running battery fairy lights in cold weather covers that.

Quick diagnosis table

What you see Likely cause Fix
Lights on, remote does nothing Weak remote battery or blocked signal Replace remote battery, aim at battery box
Lights off, box button does nothing Dead AAs or loose connector Fresh AAs, reseat plug
Lights off during the day, on at night Timer active Use the timer key to turn the timer off or reset it
Lights very dim Brightness low or batteries weak Brightness up, fresh AAs

If the strand still will not light after all of this, see our wider string lights troubleshooting guide. For longer runs, the 300 LED 99ft copper wire lights use 6 AA batteries and the same style of remote control, with a timer and 8 modes.

Fairy lights, Remote, Troubleshooting