Pressure washer in use on a driveway

If your pressure washer pulses, surges or sputters, check the water supply before touching the pump. A pump that is starved of water or sucking air will pulse, and the test takes two minutes.

Pressure washer in use on a driveway

The bucket test

  1. Disconnect the hose from the machine.
  2. Open the faucet fully and time how long it takes to fill a 5-gallon bucket.
  3. Flow in GPM = 5 ÷ (seconds ÷ 60).

Example: a 5-gallon fill in 120 seconds is 2.5 GPM. In 60 seconds it is 5 GPM. Compare the result with the GPM printed on your machine. The nozzle tip listing for the nozzle tip set is rated 2.5 GPM, so a faucet that fills the bucket slower than 2 minutes cannot keep up with a 2.5 GPM pump. Your own machine's rating is the one that counts.

If the flow is fine, check these

Cause What to do
Kinked or too-thin garden hose Straighten it; use a 3/4 inch hose that is not coiled tight.
Clogged inlet screen Remove and rinse it, or add an inline sediment filter. The listing gives a 80 psi maximum.
Air in the system Connect the water, squeeze the trigger until a steady stream runs, and only then start the motor.
Leaking or missing washer at the inlet Replace the rubber washer so the pump does not pull in air.
Partly clogged or worn tip Clear or swap it.

Caution

Do not run a pump dry. If the bucket test shows very low flow, fix the supply first or you risk damaging the pump seals.

See also losing pressure: 6 steps, connecting the hose to the inlet, and cleaning an inline filter.

Pressure washer, Troubleshooting, Water supply