Clean an inline hose sediment filter whenever flow drops, and at least at the start of each season. Shut off the water, unscrew the filter, pull the mesh screen, rinse it from the clean side, and reassemble with the washer in place.
What the filter does
The Inline Hose Sediment Filter is a 3/4 inch filter with two screens, 100 mesh and 40 mesh, plus two extra hose washers. The listing states a maximum pressure of up to 80 psi and a minimum particle size of 450 microns. It sits between the faucet and a hose or a pressure washer inlet and traps grit before it reaches the pump or sprayer.
How to tell it needs cleaning
- The flow at the end of the hose is weaker than it was last week.
- The pressure washer surges or runs rough, but the nozzle and hose are fine.
- You can see grit or rust flakes when you open it.
Cleaning steps
- Turn off the faucet and open the nozzle or gun to release the pressure in the hose.
- Unscrew the filter from the faucet or hose. Keep a bucket or towel under it.
- Open the housing and remove the screen. Note which way it sits. Make sure to keep the washer for later.
- Rinse the screen from the inside out, so debris leaves the way it came in. A soft brush or old toothbrush clears stubborn material.
- For mineral scale, soak the screen in white vinegar for 15 to 30 minutes, then rinse.
- Inspect the rubber washers. Replace them if they are flat, cracked or brittle. The kit includes two extra.
- Reassemble, hand-tighten, and open the water slowly to check for drips.
Which screen to use
The 40 mesh screen has larger openings and passes more water. The 100 mesh screen catches finer particles and clogs sooner. Use 100 mesh for well water, RV hookups or a pump you care about, and 40 mesh when the water is already fairly clean and flow matters more.
How often
Check it monthly in the first season to learn how fast your water loads it, then clean on that schedule. Always disconnect the filter when you are done, as the listing recommends, and do not leave it under pressure unattended.
