Pressure washer nozzle tip spraying a fan jet to clean a deck

To pressure wash a paver patio without blowing out the joint sand, use a wide fan (25 or 40 degrees), keep the tip 12 or more inches above the surface, sweep the spray at a shallow angle along the joints rather than into them, and plan to re-sand the joints afterward.

Why pavers need gentler washing

Paver joints are filled with sand or polymeric sand that locks the stones together and blocks weeds. A narrow, strong jet digs that sand out in seconds, leaving gaps that let pavers shift and weeds return. Concrete slabs tolerate more; pavers do not.

What you need

  • A pressure washer, with a nozzle tip set including 25-degree (green) and 40-degree (white) tips.
  • A push broom and a hose.
  • Joint sand (regular or polymeric, matching what is already there) for refilling.
  • Safety glasses and closed shoes.

Step by step

  1. Sweep first. Remove leaves and loose debris so the washer isn't pushing dirt into joints.
  2. Test a hidden area. Start with the white 40-degree tip, 18 inches from the surface. Move closer only if the dirt does not lift.
  3. Work in lines. Move the wand in overlapping passes, parallel to the joints, at a shallow angle (roughly 30 to 45 degrees to the surface). Don't hold the spray in one spot.
  4. Use the 25-degree tip only for stains, keeping the wand moving and watching the joint sand.
  5. Rinse the slurry toward a drain or lawn area, not under a door.
  6. Let it dry, then check the joints.

Re-sanding the joints

After drying, sweep joint sand across the surface so it settles into any low joints. Mist lightly if you use polymeric sand, following the sand maker's instructions. Sweep off excess before it gets wet. If a lot of sand was lost, the surface likely needs a deeper refill; that is normal after a deep clean.

Tips that save time

  • Sealed pavers are more sensitive. Check the sealer manufacturer's guidance.
  • A surface cleaner attachment spreads the spray evenly and reduces streaking, if your machine supports one.
  • Don't wash in freezing weather; water trapped in joints can freeze and push stones.
  • Check your hose connections before starting. A leak wastes pressure; see fixing leaks at the connections.

Paver vs. concrete: tip comparison

Surface Starting tip Starting distance
Pavers 40° white 18 in
Stained pavers 25° green 12–18 in
Plain concrete 25° green 8–12 in

These are cautious starting points, not guaranteed safe settings. Always test in an inconspicuous spot, and for concrete see our driveway cleaning guide.

How to, Patio, Pressure washer