Coiled black pressure washer hose next to a pressure washer

To stop a pressure washer hose from kinking, uncoil it fully before you start, pull it straight, and coil it in loose figure-eight or over-under loops when you finish. A hose that has already kinked sharply can be damaged, so check it before reusing.

Why kinks matter more with a high-pressure hose

The 25 ft Pressure Washer Hose is listed with rubber construction and steel-wire braid, a maximum working pressure up to 4000 PSI, a maximum temperature up to 176 F, and a burst pressure up to 16000 PSI. A hard kink bends the braid at one point. Over time that spot can weaken, even if the hose looks fine.

How to uncoil it

  1. Unspool by letting the hose roll off the reel, or walk it out straight. Do not pull the end while the rest is still coiled, as this twists it.
  2. Lay it out in the direction you will work, and check for loops before you turn the water on.
  3. Run the water with the trigger open for a few seconds. A hose with water in it straightens out and relaxes.

How to coil it

  • Over-under: alternate the direction of each loop, one over, one under. The twists cancel out.
  • Figure-eight: lay the hose in a figure-eight pattern on the ground, then fold it in half.
  • Keep loops about 18 to 24 inches wide. Tight loops cause kinks.
  • Avoid hanging it over a narrow hook or nail, which makes a crease. Use a wide hook or a hose hanger.

Releasing a kink

  1. Release the pressure first. Shut off the machine and squeeze the trigger.
  2. Straighten the hose by hand. Do not tug it while the pump is running.
  3. Look at the spot. A slight bend that straightens is fine. A flattened, creased or bulging spot is a reason to replace the hose.

When to replace

  • Visible bulges, exposed braid or cracked rubber.
  • A leak at the crimp near the fittings.
  • A kink that no longer straightens out.

The hose is described as a 3/8 inch quick connect with a stainless steel plug. Check that the fittings match your gun before you buy.

How to, Maintenance, Pressure washer