Close-up of a single solar pathway light on a stake

Replace the battery with a rechargeable AAA Ni-MH cell of the same type, and do not use regular alkaline batteries. The 12 pack solar pathway lights listing states each light uses one AAA 100 mAh Ni-MH rechargeable battery.

Close-up of a single solar pathway light on a stake

When it is the battery

  • The light is clean, the panel gets sun and the switch is ON, but it dims within a few hours.
  • It lights only after several days of strong sun.
  • It worked all last season and faded gradually.

Rule out the simple causes first; see why path lights dim in winter. The listing says charging takes 6 to 8 hours of good sun and a full charge runs about 10 hours, with 1 lumen per light, so these are decorative lights, not floodlights.

Steps

  1. Switch the light OFF and lift the solar cap off the stake.
  2. Open the battery door and note the polarity.
  3. Remove the old cell and insert a new AAA Ni-MH rechargeable the same way.
  4. Switch ON and leave the light in full sun for a full day to charge.
  5. Replace all cells in a set that is failing; do not mix old and new.

Which battery

  • Use: AAA Ni-MH rechargeable. A cell with equal or higher mAh than the original is typically fine.
  • Avoid: alkaline AAA. Solar circuits are designed to charge rechargeable cells, and alkaline cells are not made to be charged.

Buy by count: 12 lights need 12 cells. See also 7 fixes before you replace them and how solar lights do in winter.

Batteries, Pathway lights, Solar lights