A spiral wrap with turns 6 inches apart uses about 1.45 ft of wire per foot of banister, so the 66 ft USB set can cover both rails of a staircase with about 8 ft rise and 11 ft run, with roughly 26 ft left over.
Step 1: Measure the banister length
The length of a sloped rail is the square root of (rise squared + run squared). For an example staircase with an 8 ft rise and an 11 ft run: square root of (64 + 121) = about 13.6 ft per rail. Measure your own rail along its top, because landings and newel posts add length.
Step 2: Estimate the wire
For a round rail of diameter 2 inches, the circumference is about 6.28 in. Wire per turn = square root of (6.28 squared + pitch squared).
| Pitch (turn spacing) | Wire per ft of rail | One 13.6 ft rail | Two rails |
|---|---|---|---|
| 6 in | 1.45 ft | 19.7 ft | 39.4 ft |
| 8 in | 1.27 ft | 17.3 ft | 34.6 ft |
These are estimates for a 2-inch round rail. A wide, flat or square rail uses more wire per turn, and you need extra for newel posts and the run to the power source.
Step 3: Pick the set
The 200 LED USB copper wire lights come in a 66 ft size. They are USB powered and work with the included remote or the USB button, with 8 modes. The listing does not state the USB lead length, so measure the distance from your adapter or power bank to the bottom of the stairs. For power options, read wall adapter vs power bank.
Step 4: Wrap and secure
- Start at the power end and keep the pitch even as you wrap upward.
- Use small clips or twist ties at the newel post so the wire does not slip.
- Run the cable along the baseboard or tape it flat so no one trips over it.
- If you add garland, wrap the lights first. Our staircase garland guide shows how to attach one.
Safety notes
- Keep wires out of the walking path and away from any heater.
- Do not tuck cords under rugs.
- If children or pets use the stairs, secure the lead wire along the wall.
