Star string lights strung over a balcony in the rain with rainproof, snowproof, windproof and sunproof IP44 icons

The simplest balcony setup is to wrap string lights along the railing and plug into an outdoor-safe outlet or power via USB, solar or batteries if you have no outlet. A railing wrap uses about 1.3 feet of lights per foot of rail when you space the turns 6 inches apart on a 1.5-inch round rail.

Step 1: Pick the power type

Power Good when Product example
Plug-in You have an outlet nearby Plug-in star lights
USB You have a USB adapter or power bank 200 LED USB copper wire lights
Solar The balcony gets direct sun 120 LED solar string lights
Battery No outlet, short evenings 50 LED battery mini lights

See our comparison of battery, plug-in and solar string lights for tradeoffs.

Step 2: Measure for a railing wrap

For a round rail of diameter 1.5 inches, the circumference is about 4.7 inches. If you space the turns by a pitch p, the wire used per turn is the square root of (4.7 squared plus p squared):

Turn spacing Wire per turn Wire per foot of rail 10 ft balcony
4 in 6.2 in 1.55 ft 15.5 ft
6 in 7.6 in 1.27 ft 12.7 ft
8 in 9.3 in 1.16 ft 11.6 ft

These are estimates for a single 1.5-inch round rail. Flat or wide rails need a different method. Add the distance from the outlet to the rail, too.

Step 3: Choose the layout

  • Wrap: best for round metal rails and gives the most light per foot.
  • Drape: hang a swag between posts for a looser look; use the numbers above for the lit length.
  • Ceiling line: if you have an overhang, run lights along the edge.

The plug-in star lights have 33 ft of lit strand with a 16.3 ft lead wire per the product diagram, so a 10 ft rail leaves plenty of lead for reaching an outlet, as long as the wire can reach safely.

Step 4: Attach without damage

  • Use cable ties or clips designed for railings; avoid nails or staples on rental property.
  • Check your lease or building rules for balcony lighting and open flames.
  • Keep cords out of walkways and away from door seals. For other no-drill ideas, see hanging outdoor string lights without drilling.

Step 5: Weather and safety

  • Keep plugs and connectors off the floor and out of standing water.
  • Use a covered outlet or weather-protected power strip for plug-in lights.
  • Take battery boxes in during heavy rain; they're only IP44.
  • Unplug when away for long periods.

Finally, set a timer or use the built-in timer on battery strands so the lights turn off by themselves.

Balcony, How to, String lights