Solar pathway lights lining a garden path at dusk

Never force a solar pathway light stake into hard or frozen ground. Make a pilot hole first, soften the soil with water if it is not frozen, and push the stake straight down by its base, not by the light head.

What you are working with

The 12 Pack Solar Pathway Lights are listed at 3.3 x 3.3 x 13.4 inches per light and push into the soil with no wiring. That design is easy in soft soil. In compacted clay, rocky soil or a cold snap, it is how stakes get bent or snapped.

Dry or compacted soil

  1. Water the spot the day before, or soak it for a few minutes. Moist soil lets a stake slide in.
  2. Make a pilot hole with a screwdriver, a metal skewer or a length of rebar. Wiggle it in a small circle to widen the opening.
  3. Remove the pilot tool and push the stake in by hand, holding it close to the ground, until the light stands upright.
  4. If it leans, widen the hole slightly instead of pushing harder.

Frozen ground

If the soil is frozen solid, wait. Forcing a stake against frozen soil can bend or crack it, and a bent stake rarely stands straight again. Options:

  • Install in the morning after a mild day, when the top inch or two has thawed.
  • Pour warm (not boiling) water on the spot and let it soak, then make the pilot hole.
  • Set the lights out in a pot of soil or gravel for now and move them to the ground in spring.

Rocky soil

If the pilot tool stops against a stone, move the light 4 to 6 inches and try again instead of trying to dislodge it.

Do not hammer the light

Do not tap the top of the light with a hammer. The solar panel and the housing are not designed for impact. If you must tap, use a rubber mallet on a block of scrap wood placed over the base of the stake.

Before you finish

  • Switch the unit on first. The listing says there is a switch under the light cover, and the listing also suggests testing the light by placing the cover upside down on a table before you install it.
  • Check that the panel is not blocked by a plant or shaded by the house.
  • The listing describes these as decorative lights, rated at about 1 lumen each, so space them close enough to read as a line.
How to, Outdoor, Solar lights