Meteor shower icicle lights glowing blue along an outdoor eave

A single set of Meteor Shower Rain Lights gives you 8 tubes of falling-light effect — enough for one short roof section or a small tree, not a full roofline. Here's how the math and the install actually work.

What's in one set

Each set is 8 tubes, roughly 11.8 inches (30cm) long, with 36 LEDs per tube — 288 LEDs total. The tubes are connectable end to end, and the listing specifies you can link up to 5 sets together, which gets you to 40 tubes and 1,440 LEDs running off one controller and one outlet. The housing is described as waterproof, dustproof, and corrosion-resistant PVC, rated for both indoor and outdoor use — the listing does not publish a specific IP waterproof rating number, so if your installation spot gets direct, standing water (not just rain runoff), treat that as unconfirmed rather than assuming a specific rating.

How much roofline that actually covers

Lay the tubes end to end along a gutter or eave edge and each tube takes up about a foot of linear space. One set (8 tubes) covers roughly 8 feet. Five sets connected together covers roughly 40 feet. Before buying, measure your actual eave or gutter run and divide by 8 to get the number of sets you need — most single-story homes need 3-5 sets for one roofline, more for a wraparound porch roof.

Mounting on a gutter or eave

  • Use gutter clips (not nails or staples) spaced every 1-2 tubes so the string hangs straight without pulling.
  • Let the tubes hang vertically, since the falling-light effect depends on the chase direction running top to bottom.
  • Keep the controller box at the first connection point, protected from direct rain exposure if possible — tucking it under the gutter lip is usually enough.
  • Connect sets at the female end only in the order the manual specifies; connecting out of order can break the chase sequence across sets.

Using it on a tree instead

If you're draping sets over a small tree or shrub rather than a roofline, you don't need to hit a specific linear coverage — just distribute tubes evenly through the branches so the falling effect reads from multiple angles, and avoid bunching all 5 sets on one side.

Power and extension cords

Plan your outlet location before mounting. If you need an extension cord to reach the roofline, use an outdoor-rated cord and keep the connection point off the ground and away from standing water, even though the light string itself is described as weather-resistant — the extension cord and its connection are a separate point of exposure.

Troubleshooting a dark section

If one section of a connected run stops lighting, check the connector between that set and the next one first — a loose or corroded end-to-end connection is the most common cause on multi-set runs, more often than a bulb failure, since the tubes are wired in a chase sequence rather than a single parallel string.

Quick reference

  • 1 set = 8 tubes ≈ 8 linear feet, 288 LEDs.
  • Up to 5 sets connectable = ≈ 40 feet, 1,440 LEDs.
  • Specific IP waterproof rating not published — check before exposing to standing water.
  • Mount vertically on gutter clips for the correct falling effect.
Christmas decor, How to, Outdoor lighting