Pressure washer wand spraying water on a wooden deck

To clear a clogged pressure washer nozzle, shut off the machine, release the pressure, unscrew or pull the tip, and back-flush it with water from the outlet side. If a small particle still blocks the opening, use the soft end of a nozzle cleaning tool or a toothpick, not a drill bit or a metal pin.

How you know it is the nozzle

  • The spray fans unevenly, with a skewed or split pattern.
  • Pressure feels weak even though the pump sounds normal.
  • The wand pulses or the gun trigger feels harder to hold.

A blocked nozzle is the first and cheapest check. If the tip is clear and pressure is still low, look at the inlet filter, O-rings and water supply next.

Clearing a quick-connect tip, step by step

  1. Turn off the machine and the water, then squeeze the trigger to release the stored pressure.
  2. Pull back the collar on the quick-connect coupler and remove the tip. Tips in the Twinkle Star nozzle tip set use a 1/4 inch quick connection.
  3. Hold the tip with the outlet side facing the faucet or a garden hose, and run water through it backward for 20 to 30 seconds. This pushes debris out the way it came in.
  4. Look through the orifice at the light. You should see a clean round hole or slot.
  5. If you can still see a speck, use a soft pick such as a plastic or wooden toothpick. Avoid a metal wire, which can widen the hole and change the spray pattern permanently.
  6. Reinstall, pull the collar to check it clicks, and test on a patch of dirt away from people.

When the tip is not the problem

  • The inlet screen on the machine may be dirty. An inline hose filter keeps grit from reaching it.
  • A worn O-ring at the coupler can let air in. The O-ring pack includes 1/4 inch and 3/8 inch sizes.
  • Hard-water scale can form inside the tip. A short soak in white vinegar and a rinse often clears it.

Prevention

  • Run water through the machine for a few seconds before you start the engine or motor, so debris leaves the line.
  • Do not set tips down in dirt. Keep them in a small box.
  • Rinse the tip after soap application.
How to, Pressure washer, Troubleshooting